Step 2 – Tapered Threads v. Parallel Threads. Next, determine if the thread is tapered or parallel. Tapered threads become narrower as they extend outward while parallel threads remain the same diameter. Sometimes this characteristic can be determined through visual inspection, but if not a caliper can come in handy. ITA Class III Forklift Forks 1.5" x 8" x 48" Full Taper (9,180lbs* @ 24" Load Center) Often referred to as Lumber Forks or Plywood Forks, these fork tines are different than standard taper forks in the sense that the taper starts near the heel and continues all the way to the the tip of the fork. Tips on fully tapered forks are typically Nobble. Posted: Dec 19, 2011 at 12:54. Quote. a tapered fork will only fit a bike with a 1.5 or tapered headtube. a non-tapered fork can be bought in 1.5 (only fit 1.5 frames) or 1 1/8th steerer Working with Sean Chaney at Vertigo Cycles, Cane Creek is set to launch their new XX 44mm Traditional headset system in June, which will allow some frames with standard 1-1/8″ headtubes to run the newer tapered steerer suspension forks. For older bikes designed with a 44mm bore 1-1/8″ ZeroStack headtube ( like Giant, Gary Fisher, BMC, Scott Where the original AX fork didn’t accommodate many drop-bar standards, the new Taper-Cast fork does with a 12x100mm thru-axle, flat-mount caliper compatibility, and a slimmer crown and leg design that accommodates more frame designs. What remains are the 32mm stanchions and 1 1/2- to 1 1/8-inch tapered steerer tube. Tapered head tubes offer the following advantages: Stiffer and thus more responsive front end; Potentially stronger head and down tube (whether this is the case depends on the particular frame) Upgrade path to a higher-end fork. It’s possible to install a non-tapered fork on a tapered head tube via a reducer. AxAra.

perbedaan fork taper dan non tapered